Home > Company News > DZW Non intrusive Electric Actuator
Company News
1. Functional characteristics
A. Reliable magnetic conduction knob is used for local operation, and the traditional through knob design or waterproof rubber button design is abandoned, ensuring the waterproof performance and durability of the equipment and meeting the conditions for outdoor application.
B. Multi function display window, with rich display contents, the user can grasp the basic setting parameters and operation status of the equipment at any time, and the fault alarm information is clear at a glance.
C. Automatic phase detection and correction of three-phase power supply, on-site installation does not need to care about the phase sequence, thus avoiding the problem of equipment damage caused by installation. Automatic protection against phase failure to protect equipment.
D. It has complete fault detection functions such as locked rotor and oscillation judgment. After the equipment detects a fault, it will stop working to protect the equipment and the entire system, and display fault information through the display screen. Built in four passive contacts are used to output the valve open in place, the valve closed in place, the comprehensive fault, and the control mode (on-site/remote).
E. A variety of working modes can be set on site: positive and negative action modes can be set, and full open, stop, and full close action modes of valves can be set when the control signal is interrupted.
F. Instantaneous reverse protection. For example, when the valve opening action is being executed, the actuator will stop the action after receiving the valve closing command, and then execute the valve closing action after delaying a preset time to reduce the impact on the equipment.
G. The compound type can use a switching value signal to switch the control mode (automatic/manual), which is convenient for users to realize remote automatic/manual control.
1. The locked rotor can be removed in the opposite direction remotely without power failure or on-site operation.
2. Technical parameters
A. Input and output signals: 4-20mA, 0-10V, 1 - 5V, switch, MODBUS, 4 passive point outputs (expandable)
B. Working power supply: 380VAC, 220VAC, 110VAC, 24VAC
C. Actuator position feedback signal: 12 bit single turn encoder
D. Input impedance: 4-20mA input 180 Ω
E. Positioning accuracy: up to 0.4%
F. Working environment: temperature - 25 ℃ - 50 ℃, humidity ≤ 95%
G. Protection grade: IP67
- Sand Water Filter/Water treatment plants
- Automatic Doypack Seal Machine (insert and sealing machine)
- IPX3/IPX4 Hand-held Water Spray Nozzle Test Device IEC 60529
- IPX5,IPX6 Jet Nozzle of IEC 60529, Brass material
- Adjustable and multifunctional Spring Impact Hammer IK01-IK07 Level Tester
- Test probe 43 IEC 61032-Probe 43-Figure 17 Jusdtest
- IEC61032-Probe 41-Figure 16 Test probe 41
- IEC61032-Probe 32-Figure 15 Test probe 32
- Test probe 31 IEC61032-Probe 31-Figure 14
- Jointed Child Finger Probes IEC 61032-Probe 19-Figure 13 R 2.5±0.05 mm
- Test probe 18 of IEC 61032 R4.3mm Jointed Child Finger Probes
- Digital recorder for Lugeon testing